3.2 Operating Procedures for Utility Functions
3.2.39 JOG Speed Table Initialization (FnB08)
3-124
* If the key is pressed in an operation prohibited state, “Error.” is displayed for
approximately 2 seconds and then the display returns to the FnB08 operation screen.
In this case, make the setting again by referring to Preparation on page 3-123.
2
Press the key to view the
FnB08 operation screen.
3
Press the key to start JOG
speed table initialization.*
Do not turn off the control power
supply until initialization has been
completed normally.
To cancel the FnB08 operation,
press the key before pressing
the key. The display returns to
the Utility Function Mode main
menu without executing the opera-
tion.
4
When JOG speed table initialization
has been completed normally,
“Done.” is displayed.
5
Press the key to return to the
Utility Function Mode main menu.
Continued from previous page.
Step Operation Result
㹀㹀ࠉࠉࠉࠉࠉ㹈㹱㹮㹢㹇㹬㹧㹲
ࠉ㹑㹲㹟㹰㹲ࠉ㸸㹙㹂㸿㹒㸿㹛
ࠉ㹐㹣㹲㹳㹰㹬㸸㹙㹑㹃㹒㹛
㹀㹀ࠉࠉࠉࠉࠉ㹈㹱㹮㹢㹇㹬㹧㹲
㹐㹣㹱㹲㹭㹰㹧㹬㹥ࠉ㹬㹭㹵㸬㸬㸬
㹎㹪㹣㹟㹱㹣ࠉ㹵㹟㹧㹲㸬
㹀㹀ࠉࠉࠉࠉࠉ㹈㹱㹮㹢㹇㹬㹧㹲
㹂㹭㹬㹣㸬
㹎㹰㹣㹱㹱ࠉ㹙㹑㹃㹒㹛ࠉ㹩㹣㹷㸬
㹀㹀ࠉࠉࠉࠉࠉ㹄㹓㹌㹁㹒㹇㹍㹌
㹄㹬㹀㸮㸵ࠉ㹘㹍㹌㹃ࠉ㹇㹬㹧㹲
㹄㹬㹀㸮㸶ࠉ㹈㹑㹎㹂ࠉ㹇㹬㹧㹲
㹄㹬㹀㸮㸷ࠉ㹘㹑㹃㹒
㹄㹬㹀㸮㸿ࠉ㹋㹭㹬㹧㹲㹭㹰
To Next Page
Loading...
Need help?
General
