YASKAWA E-7 Series User Manual

4.2 Operating Procedures in Parameter Copy Mode
4.2.2 Writing Parameters to the SERVOPACK (OP→SERVO)
4-7
4
Parameter Copy Functions
5
Press the Key.
Writing the parameters to the SER-
VOPACK will start.
Note: While the power is supplied to the
motor (i.e., while RUN is dis-
played) or while writing the param-
eters is prohibited, Not Available
will be displayed if the
Key is pressed and the parameters
will not be written.
Completed will be displayed when
the parameters have been read
from the specified block in the Digi-
tal Operator and saved in the SER-
VOPACK.
Also A.941 (Change of Parameters
Requires Restart) will be displayed.
After Completed is displayed, the
Parameter Block Selection Display
will appear.
Continued on next page.
Continued from previous page.
Step Operation Result
00:S GD7S -R70
Reading
Parameters ..
<< OP >>
1:BB OP
→
S ERVO
00:S GD7S -R70
Completed
1:A. 941 OP
→
S ERVO
00:S GD7S -R70
01:
****
02:
****
0 3 :
****
1:A.941 OP
→
S ERVO

YASKAWA E-7 Series Specifications

General

Brand	YASKAWA
Model	E-7 Series
Category	Servo Drives
Language	English