4.2 Operating Procedures in Parameter Copy Mode
4.2.4 Parameter Block List Display (LIST)
4-15
4
Parameter Copy Functions
5
Press the Key.
Deleting the parameter block will be
started.
Note: If power is supplied to the motor
(i.e., if RUN is displayed) when the
Key is pressed, Not
Available will be displayed and the
parameters will not be deleted.
When the selected parameter block
has been deleted, Completed will
be displayed.
After Completed is displayed, the
Parameter Block Selection Display
will appear. “****” will be displayed
for the deleted block to indicate that
it is an empty block.
6
Press the Key.
The display will return to the Param-
eter Copy Mode Main Menu.
Continued from previous page.
Step Operation Result
00:S GD7S -R70
Deleting
Parameters ..
1:BB LIS T
00:S GD7S -R70
1:BB LIS T
Completed
00:
****
01:
****
02:
****
0 3 :
****
1:BB LIS T
1:S ERVO
→
OP
2:OP
→
S ERVO
3 :VERIFY
4:LIS T
1:BB COPY
To Next Page
Loading...
Need help?
General
