YASKAWA FSDrive-MV1000 Series - The Drive and Programming Modes

4.3 The Drive and Programming Modes
YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions 113
Start-Up Programming & Operation
4
4.3 The Drive and Programming Modes
The drive has a Drive mode to operate the motor and a Programming Mode to edit parameter settings.
Drive Mode: In Drive Mode, the user can start the motor and observe operation status with the available monitors.
Parameter settings cannot be edited or changed when in the Drive Mode.
Programming Mode: In Programming Mode the user can edit and verify parameter settings and perform Auto-Tuning.
When the drive is in Programming Mode it will not accept a Run command unless b1-08 is set to 1.
Table 4.4 describes the functions accessible by pressing the ⋅ keys of the digital operator.
Table 4.4 Modes
Mode Contents Key LCD Display
Drive Mode
(Operation/operation status
monitor of the motor)
Frequency Reference
x
Monitor Display
x
Programming Mode
(Parameter setting)
Verify Menu
x
Setup Group
x
Parameter Setting Mode
x
Auto-Tuning Mode
x
- MODE - PRG
Modified Consts
HELP DATA
FWD
Modified
X Parameters
HELP
- MODE - PRG
Quick Setting
DATA
FWD
HELP
- MODE - PRG
DATA
Programming
FWD
HELP
- MODE - PRG
Auto-Tuning
DATA
AUTO
FWD