4.3 The Drive and Programming Modes
YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions 119
Start-Up Programming
& Operation
4
u Setup Group Parameters
n Setup Group (SETUP)
Only the frequently used parameters are selected into the setup mode to simplify drive setup. Take the following steps to
modify parameters in the Setup Group:
1.
Press or until the “Setup Group” screen is displayed.
2. Select a parameter, and change the setting. Table 4.5 shows the parameters that can be used in the Setup
Group. Use the “Parameter Setting Mode” screen to access parameters not found in the Setup Group.
Note: Changing parameter A1-02 will automatically change values of other parameters.
Table 4.5 Setup Group Parameters
Note: Parameter availability depends on the control mode set in A1-02; some parameters listed above may not be accessible in all
control modes.
No. Name No. Name
A1-02 Control Method Selection E1-05 Maximum Voltage
A1-06 Application Preset E1-06 Base Frequency
b1-01 Frequency Reference Selection 1 E1-09 Minimum Output Frequency
b1-02 Run Command Selection 1 E1-13 Base Voltage
b1-03 Stopping Method Selection E2-01 Motor Rated Current
C1-01 Acceleration Time 1 E2-04 Number of Motor Poles
C1-02 Deceleration Time 1 E2-11 Motor Rated Power
d1-01 Frequency Reference 1 H4-02 Analog Output 1 Gain
d1-02 Frequency Reference 2 H4-12 Analog Output 2 Gain
d1-03 Frequency Reference 3 H4-22 Analog Output 3 Gain
d1-04 Frequency Reference 4 H4-32 Analog Output 4 Gain
d1-17 Jog Frequency Reference L1-01 Motor Overload Protection Selection
E1-01 Input Voltage Setting L3-04 Stall Prevention Selection during Deceleration
E1-04 Maximum Output Frequency
To Next Page
Loading...
