5.9 Copy Function Related Displays
YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions 179
5.9 Copy Function Related Displays
u Tasks, Errors, and Troubleshooting
When executing the tasks offered by the copy function, the digital operator indicates the task being performed. When an
error occurs, a code appears on the digital operator to indicate the error. Note that errors related to the Copy function do
not trigger a contact terminal set for fault or alarm output. Press any key on the digital operator to clear an error.
Table 5.18 lists the corrective action that can be taken when an error occurs.
Note: 1. The drive should be fully stopped when using the copy function.
2. The drive will not accept a Run command while the copy function is being executed.
3. Parameters can only be saved to an drive when the voltage class, capacity, control mode, and software version match.
Table 5.18 Copy Function Task and Error Displays
Digital Operator Display Error Name
CoPy Writing Parameter Settings (flashing)
Cause Possible Solutions
Parameters are being written to the drive. This is not an error.
Digital Operator Display Error Name
CPEr
Control Mode Mismatch
Cause Possible Solutions
Control mode of the parameters to be loaded
onto the drive and the control mode already set
to the drive do not match.
• Check the control mode for the parameters that are to be loaded onto the drive and the control
mode set to the drive to which those parameters will be written.
• Set the same control mode using parameter A1-02 and retry.
Digital Operator Display Error Name
CPyE Error Writing Data
Cause Possible Solutions
Failed writing parameters. Attempt to write parameters again.
Digital Operator Display Error Name
CSEr Copy Unit Error
Cause Possible Solutions
Hardware fault Replace the digital operator or the USB Copy Unit.
Digital Operator Display Error Name
dFPS Drive Model Mismatch
Cause Possible Solutions
The drives used in the copy and write process are
not the same model.
• Check the model number of the drive from which the parameters were copied and the model of
the drive to which those parameters will be written.
Make sure the two drives are the same model and have the same software version.
Digital Operator Display Error Name
End Task Complete
Cause Possible Solutions
Finished reading, writing, or verifying
parameters
This is not an error.
Digital Operator Display Error Name
iFEr Communication Error
Cause Possible Solutions
A communication error occurred between the
drive and the digital operator or the USB Copy
Unit.
⇒Check the cable connection.
A non-compatible cable is being used to connect
the USB Copy Unit and the drive.
⇒Use the cable originally packaged with the USB Copy Unit.
To Next Page
Loading...
