YASKAWA FSDrive-MV1000 Series - Subchart A-1: Parallel Operation of Multiple Motors by V;F Control

4.4 Start-Up Flowcharts
YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions 121
Start-Up Programming & Operation
4
u Subchart A-1: Parallel Operation of Multiple Motors by V/f Control
Subchart A-1 describes simple motor setup for V/f Control without PG feedback.
Figure 4.9
Figure 4.9 Parallel Operation of Multiple Motors by V/f Control
From
Flowchart
A
Run the motor without load; check the rotation direction and operation.
Verify external signal commands to the drive work as desired.
Couple the load or machine to the motor.
Run the machine and check for desired operation.
Return to
Flowchart
A
Set E1-
 (V/f pattern).
Turn on the main circuit power.