3.4 Cable Routing
88 YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions
u Cable Routing Precautions
NOTICE: The area where the cables enter the bottom of the drive should be tightly sealed with fire-resistant putty so that no open
space remains. Make sure the entire peripheral areas around the channel base and the pit cover are tightly sealed with the putty so
that no opening remains. A proper operating environment cannot be maintained if air or dust from the outside makes its way into the
drive, and can result in damage to the equipment.
Figure 3. 16
Figure 3.16 External Cable Inlet Port
A – Bracket grounding terminal B – Completely seal the external cable inlet
port with fire-resistant putty so no
open space remains
To Next Page
Loading...
