5.1 Section Safety
YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions 139
Observe proper electrostatic discharge procedures (ESD) when handling the drive.
Failure to comply could result in ESD damage to the drive circuitry.
Do not disconnect the motor from the drive while the drive is outputting voltage.
Failure to comply could result in damage to the drive.
Use only shielded cable to wire analog input/output signals for the control circuit.
Failure to comply could result in drive malfunction.
Use shielded twisted-pair wires and ground the shield to the ground terminal of the drive.
Do not modify the drive circuitry.
Failure to comply could result in damage to the drive and will void warranty.
Do not attempt to modify or alter the drive.
Yaskawa is not responsible for any modification of the drive made by the user.
Check all the wiring and ensure that all connections are correct after installing the drive and connecting other
devices.
Failure to comply could result in damage to the drive.
To Next Page
Loading...
