YASKAWA SGD7S-****20A Series - Page 549

13.3 Parameter Recording Table
13-62
*1. The enable timing depends on the digit that is changed. Refer to the following section for details.
13.1 List of Servo Parameters on page 13-2
*2. The parameter setting is enabled after SENS_ON command execution is completed.
*3. Change the setting when the reference is stopped (i.e., while DEN is set to 1). If you change the setting during
operation, the reference output will be affected.
91
PnB22
0FFF3F33h
SVCMD_ STAT bit Enabled/
Disabled (read only)
−
92
PnB24
007F01F0h
I/O Bit Enabled/Disabled
(Output) (read only)
−
93
PnB26
FF0FFEFEh
I/O Bit Enabled/Disabled
(Input) (read only)
−
Continued from previous page.
Parameter
No.
Default Setting Name
When
Enabled