8 Development Support Tool
8.6 Port Debug
8-12
HW1484528
HW1484528
8.6.2 Optional for Measuring
Trigger If the option is enabled, only the measuring data is
displayed when the trigger conditions are satisfied.
Set the port number and trigger conditions to apply the
trigger. The trigger conditions are shown below.
Up Detects the rising edge.
Down Detects the falling edge.
Up&Down Detects both edges, rising and falling.
Level Detects exceeding of the threshold level.
Fig. 8-11: Trigger
Org Position Adjusts the display of the home position of the
measuring data.
Depending on the adjustment of the home position, the
displays differ as shown below.
(When the trigger is "UP")
Fig. 8-12: Home Position
Measure Time When the option is enabled, two cursors for measuring
and the time between the cursors are displayed.
When adjusting the position of the cursors, any time
can be measured.
Fig. 8-13: Measure Time
To Next Page
Loading...
