2 Development Environment Setup
2.3 Installation of TELNET Connection Utility
2-4
HW1484528
HW1484528
2.3 Installation of TELNET Connection Utility
To debug the MotoPlus application, connect the YRC1000micro and the
PC via TELNET and describe using printf() in the application program.
Thus, the TELNET connection utility is prepared. Install it by following the
procedure below.
1. Copy the entire “YRC1000_TELNET” folder in the MotoPlus
installation DVD into an appropriate hard disk of the PC.
(“YRC1000_TELNET.exe” and “YRC1000_TELNET.ini” must be in the
same folder.) Run “YRC1000_TELNET.EXE” to connect to the
YRC1000micro via TELNET.
2. Also, configure the settings of TELNET connection by
“YRC1000_TELNET.ini”. Set the IP address of the YRC1000micro
here.
ipaddress: IP address of the YRC1000micro
(Set the same IP address as the one set in the HOST
SETUP window.)
sendtime: Waiting time from the startup of “YRC1000_TELNET.EXE”
until starting the TELNET connection (default value: 8,
unit: sec)
inputTime: Waiting time from starting the TELNET connection until
starting to login (default value: 4, unit: sec)
3. Insert the provided hardware key into any available USB connector.
The message “Your new hardware is installed and ready to use.” will
appear in the taskbar.
When the setup utility completes, you must also install the
system driver for the hardware key. Start “Sentinel System
Driver Installer 7.5.9.exe” to install the driver.
To Next Page
Loading...
Need help?
General
