8 Development Support Tool
8.7 Copy Protection
8-20
HW1484528
HW1484528
8.7.4 Loading the Protection Key (MotoPlus Monitor)
Load the protection key to the controller.
1. Save the protection key file to the root folder of the memory device,
and then mount the memory device on the programming pendant.
2. Select {Protection Key} in MotoPlus Monitor.
3. Select the memory device which the protection key is saved to.
4. Press {Open}.
5. The key file list on the memory device appears. Select the key file to
load.
6. Press {Load}.
The protection key loads from the memory device to the controller. The
application which is created in chapter 8.7.1 “Protection Activation
(MotoPlusIDE)” can be used. Copy protection procedures are complete.
Fig. 8-18: Protection Key Download Window
• The protection key cannot be generated if the project of
the application does not exist.
• The protection key cannot be generated if the project of
the application is not built.
To Next Page
Loading...
