Yealink CP960 - Phone Status

Customizing Your Phone
41
l Personal Identification Number (PIN): The user has to enter a WPS PIN generated randomly by the IP phone on the
gateway/router to connect.
Before You Begin
Make sure that the Wi-Fi mode is activated.
Push Button Configuration (PBC)
Procedure
1. Navigate to Settings->Basic Settings->Wi-Fi.
2. Tap
and then tap WPS.
The touch screen prompts “Press the Wi-Fi Protected Setup button on your router. It may be called “WPS” or con-
tain this symbol:”.
3. Long press the WPS key on your gateway/router.
Once WPS setup has completed successfully, the touch screen will prompt “Connected”.
Personal Identification Number (PIN)
Procedure
1. Navigate to Settings->Basic Settings->Wi-Fi.
2. Tap
and then tap WPS-PIN.
The touch screen prompts “Enter pin XXX on your Wi-Fi router. The setup can take up to two minutes to com-
plete.”.
3. Note the PIN code.
4. Log into your gateway/router’s web interface, and configure it to search the clients. For more information, refer to
the documentation from the gateway/router manufacturer.
Once the WPS-PIN setup has completed successfully, the gateway/router’s web interface will prompt success.
Adding a Wireless Network Manually
If your gateway/router has SSID broadcast disabled, it might not appear in the scanning results. In that case, you must
manually add a wireless network.
Before You Begin
Get the available wireless network information from your system administrator. Make sure that the Wi-Fi mode is activ-
ated.
Procedure
1. Navigate to Settings->Basic Settings->Wi-Fi.
2. Tap
->Add.
3. Enter the desired value in the Network SSID field.
4. Tap the Security field.
5. Tap the desired value.
l If you select WEP or WPA/WPA2 PSK, enter the password in the Password field.
l If you select 802.1x EAP, tap the EAP method field, select the desired EAP method and then enter the desired
values in the corresponding fields.
6. Do the following: