Yealink CP960 - Enabling;Disabling the DND Mode for a Conference Call; Managing the Conference Participants; Network Conference; Setting up a Network Conference

Call Features
87
Enabling/Disabling the DND Mode for a Conference Call
Procedure
1. Tap DND to enable the DND mode.
2. Tap DND again to disable the DND mode.
Managing the Conference Participants
You can manage conference participants in the following ways:
l Mute a participant.
l Hold a participant
l Remove a participant from the conference
l Split the participant from the conference
l View the participant information
Procedure
1. Tap the avatar of desired participant, you can do the following:
l Tap Far Mute to mute the participant. The muted participant can hear everyone, but no one can hear the muted
participant.
l Tap Remove to remove the participant from the conference.
l Tap Split to split the participant from the conference.
l Tap Hold to hold the participant.
l Tap Detail to view the participant information.
l
Tap to return to the conference screen.
Network Conference
If your system administrator has set a network conference feature on your phone, you can initiate a conference with
multiple participants.
Topics
Setting Up a Network Conference
Setting Up a Network Conference
Procedure
1. Place a call to the first party.
2. When the first party answers the call, tap Invite or tap one of the empty round space.
3. Do one of the following:
l Enter the number of the second party, and then tap Invite.
l Tap Call multiple members? Click here >>, enter the number of the new party, and then tap Add members.
Repeat the step above until you add all intended parties.
Tap
to call all intended parties at the same time.
The conference is set up after the intended parties answer the call.
Note
The procedures for setting up a network conference call on specific servers may be different from the introduction above.