Zebra TC25

DataWedge
80
Touch to return to the previous screen.
Decoder Params
Use Decode Params to configure individual decoder parameters.
Codabar
• CLSI Editing - Enable this parameter to strip the start and stop characters and insert a space after the
first, fifth, and tenth characters of a 14-character Codabar symbol. Enable this feature if the host
system requires this data format (default - disabled).
• Length1 - Use to set decode lengths (default - 6). See Decode Lengths on page 85 for more
information.
• Length2 - Use to set decode lengths (default - 55). See Decode Lengths on page 85 for more
information.
• NOTIS Editing - Enable this parameter to strip the start and stop characters from a decoded Codabar
symbol. Enable this feature if the host system requires this data format (default - disabled).
• Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the
checkbox indicates that redundancy is enabled (default - enabled).
Code 11
• Length1 - Use to set decode lengths (default - 4). See Decode Lengths on page 85 for more information.
• Length2 - Use to set decode lengths (default - 55). See Decode Lengths on page 85 for more information.
• Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the checkbox
indicates that redundancy is enabled (default - enabled).
• Report Check Digit - Transmit Code 11 data with or without the check digit. A check in the checkbox
indicates to send Code 11 data with check digit (default - disabled).
Decoder Signature Disabled Disabled
TLC 39 Disabled Disabled
Trioptic 39 Disabled Disabled
UK Postal Disabled Disabled
UPC-A Enabled Enabled
UPC-E0 Enabled Enabled
UPC-E1 Disabled Disabled
US4state Disabled Disabled
US4state FICS Disabled Disabled
US Planet Disabled Disabled
US Postnet Disabled Disabled
Table 5 Supported Decoders (Continued)
Decoders Internal Imager RS6000