DataWedge
90
• Display BT Address Barcode - Enable or disable displaying Bluetooth Address bar code if there is no
Bluetooth scanner being paired when application tries to enable the Bluetooth scanner (RS6000 only).
• Establish Connection Time - The timeout which the device will try to enable or reconnect to the Bluetooth
scanner when the Bluetooth scanner is not in the vicinity or not paired (RS6000 only).
• Audio Feedback Mode - Select good decode audio indication (RS6000 only).
• Local Audio Feedback - Good decode audio indication on the device only.
• Remote Audio Feedback - Good decode audio indication on Bluetooth scanner only.
• Both - Good decode audio indication on device and Bluetooth scanner.
• Disable - No good decode audio indication on either device or Bluetooth scanner (default).
• LED Feedback Mode - Select good decode LED indication (RS6000 only).
• Local LED Feedback - Good decode LED indication on device only.
• Remote LED Feedback - Good decode LED indication on Bluetooth scanner only.
• Both - Good decode LED indication on the device and Bluetooth scanner (default).
• Disable - No good decode LED indication on either the device or RS6000.
• Decode Audio Feedback - Select an audio tone to sound upon a good decode.
• Decoding LED Notification - Enable the device to light the red Data Capture LED when data capture is in
progress. (default - disabled).
• Decode Feedback LED Timer - Set the amount of time (in milliseconds) that the green Data Capture LED
stays lit after a good decode. (default - 75 msec.)
• Beep Volume Channel - Set the good decode beep to a system or other sound. This allows for
independent control of the good beep volume.
• Ringer - Set the good decode beep to the ringer sound.
• Music and Media - Set the good decode beep to the media sound.
• Alarms - Set the good decode beep to the alarm sound.
• Notifications - Set the good decode beep to the notification sound (default).
UDI Parameters
Not applicable.
Keep Enabled on Suspend
Keep the Bluetooth scanner enabled after suspend (default - disabled).
Keystroke Output
Use to configure the Keystroke Output Plug-in for the profile.
• Enabled — Enables or disables this plug-in. A check in the checkbox indicates that the plug-in is enabled
(default - enabled).
NOTE Not all ringtones are fully supported as decode tones and those of longer length may be truncated when used
as a decode tone. The recommendation is to test the selected tone for operation before deployment to a
customer site.
To Next Page
Loading...
Need help?
General
