To Next Page

To Previous Page

Using the TC25

Transferring Files with a Host Computer via USB

Connect the TC25 to a host computer using the USB Charging cable or the 1-Slot USB cradle to transfer files

between the TC25 and the host computer. See Accessories for more information.

When connecting the TC25 to a host computer, follow the host computer’s instructions for connecting and

disconnecting USB devices, to avoid damaging or corrupting files.

Transferring Files using Media Transfer Protocol

1. Connect the Rugged Charge/USB Cable to the TC25 or place the TC25 into the 1-Slot USB/Charge Only

Cradle. See Accessories for setup information.

2. Pull down the Notification panel and touch USB charging this device.

Figure 46 Use USB Dialog Box

3. Touch Transfer files.

4. On the host computer, open a file explorer application.

5. Locate the TC25 as a portable device.

6. Open the SD card or the Internal storage folder.

7. Copy files to and from the TC25 or delete files as required.

Transferring Files using Photo Transfer Protocol

1. Connect the USB Cable to the TC25 or place the TC25 into the 1-Slot Ethernet Cradle. See Accessories for

setup information.

2. Pull down the Notification panel and touch USB charging this device.

NOTE Use Media Transfer Protocol (MTP) to copy files between the TC25 (internal memory or microSD card)

and the host computer.

NOTE Use Photo Transfer Protocol (PTP) to copy photos from either the microSD card or internal memory to the

host computer.

Zebra TC25 User Manual

Other manuals for Zebra TC25