96
Data Capture
The TC25 supports data capture using:
• integrated imager
• SE4710 scan engine
• SE2100 scan engine
• RS507 Hands-free Imager
• RS6000 Bluetooth Ring Scanner.
Imaging
The TC25 with an integrated 2D imager has the following features:
• Omnidirectional reading of a variety of barcode symbologies, including the most popular linear, postal,
PDF417, and 2D matrix code types.
• The ability to capture and download images to a host for a variety of imaging applications.
• Advanced intuitive laser aiming cross-hair and dot aiming for easy point-and-shoot operation.
The imager uses imaging technology to take a picture of a barcode, stores the resulting image in its memory, and
executes state-of-the-art software decoding algorithms to extract the barcode data from the image.
Operational Modes
The TC25 with an integrated imager supports two modes of operation, listed below. Activate each mode by
pressing the Scan button.
• Decode Mode: In this mode, the TC25 attempts to locate and decode enabled barcodes within its field of
view. The imager remains in this mode as long as the user holds the scan button, or until it decodes a
barcode.
• Pick List Mode: This mode allows the user to selectively decode a barcode when more than one barcode
is in the TC25’s field of view. To accomplish this, move the aiming crosshair or dot over the required
IMPORTANT To determine the integrated scan engine in the device, go to Settings > About phone >
Hardware components > Scanner.
NOTE To enable Pick List Mode, configure in DataWedge or set in an application using a API command.
To Next Page
Loading...
Need help?
General
