Zebra TC72 - Installing the Trigger Handle Plate

Accessories
70
2.
Feed the attachment plate through the loop.
3. Pull the attachment plate until the loop tightens on the tether.
Installing the Trigger Handle Plate
1. Press and hold the Power button until the menu appears.
2. Touch Power off.
3. Touch OK.
4. Press in the two battery latches.
5. Lift the battery from the device.
6. Remove the hand strap filler plate from the hand strap slot. Store the hand strap filler plate in a safe
place for future replacement.
7. Insert the attachment plate into the hand strap slot.
8. Insert the battery, bottom first, into the battery compartment in the back of the device.