Zebra TC72 - Replacing the SIM or SAM Card

Getting Started
30
8.
Lift the battery from the device.
CAUTION: Replace the battery within two minutes. After two minutes the device reboots and data may be
lost.
9. Insert the replacement battery, bottom first, into the battery compartment in the back of the device.
10. Press the battery down until the battery release latch snaps into place.
11. Replace the hand strap, if required.
12. Press and hold the Power button to turn on the device.
NOTE: After replacing the battery, wait 15 minutes before using Battery Swap again.
Replacing the SIM or SAM Card
NOTE: SIM replacement applies to TC77 only.
To replace the SIM or SAM card:
1. Press and hold the Power button until the menu appears.
2. Touch Power off.
3. Touch OK.