Zebra TC72 - Inserting the Device into the TC7 X Vehicle Communication Charging Cradle; Charging the Device in the TC7 X Vehicle Communication Charging Cradle

Accessories
80
CAUTION: Ensure that the device is fully inserted into the cradle. Lack of proper insertion may result in
property damage or personal injury. Zebra Technologies Corporation is not responsible for any loss
resulting from the use of the products while driving.
Figure 48 Insert Device into Cradle
Inserting the Device into the TC7X Vehicle Communication Charging Cradle
To remove the device from the cradle, press the release latch, grasp the device and lift out of the vehicle
cradle.
Figure 49 Remove Device from Cradle
Charging the Device in the TC7X Vehicle Communication Charging Cradle
Insert the device into the cradle. The device starts to charge through the cradle as soon as it is inserted.
This does not deplete the vehicle battery significantly. The battery charges in approximately four hours.
See Table 3 on page 27 for all charging indications.
NOTE: The Vehicle Cradle operating temperature is -40°C to +85°C. When in the cradle, the device will
only charge when its temperature is between 0°C to +40°C.
1
2
1
2
2
3