Limitation of the upper position of the three-point hitc
Lowering speed
Free position
Setting the control of three-point hitch
It is activated with the control (5). The limitation can be
implemented in the upper half of the three-point hitch lift.
PGPPN060
The lowering speed of the three-point hitch is set with the
control (3).
In the vibration dampening mode and during
the use of the rear control buttons the lowering speed
setting is out of function.
Symbol of the maximum
lowering speed
Symbol of the minimum
lowering speed
PGPPN071
For permanent work with free hydraulic system, e.g.
during work with a plough with a support wheel the
position of the control (4) under the indication (A) and the
position of the control (6) at the positional control symbol
is used.
PGPPN072
Electrohydraulics enables two ways of three-point hitch
control.
A. Manual control setting - control (6) is set in the range
see arrow
B. Automatic control - control (6) is set in HitchTronic
(AHC) position see arrow
Automatic control can be at any time exchanged for
manual and the other way round by a control (6).
PGPPN052
To Next Page
Loading...
