Stopping the tracto
- hand brake
Stopping the engine
Attention! When the engine is switched off, the engine control unit remains active for about 2
minutes because of storage of operation data. During this time the supply of current from the
accumulator must not be interrupted. Do not disconnect the accumulator before this time expires.
Leaving the tractor
Under normal conditions stop the tractor slowly. Shortly
before stopping:
1. Tread on the clutch pedal and brake the tractor by the
foot brake.
2. Move the main shifting lever to neutral position.
3. With each stop secure the tractor using the hand brake
against spontaneous moving off. Application of the hand
brake is indicated by a light on the dashboard.
PGPPN026
After operation of the tractor when the engine was fully
loaded the engine must be cooled.
1. When the engine is started, leave it idling without load
for ca. 5 minutes.
2. Move the manual regulation lever to the idling position.
3. When the key is turned from 'I' position to '0' position,
the engine is stopped.
PGPPN172
Before you leave the tractor with safety cabin, do not
forget remove the key in position '0' from the ignition box
(in positions I and II the key cannot be pulled out).
The tractor shall be secured against
spontaneous moving off:
1. Engine switched off.
2. 1
st
gear engaged.
3. Hand brake applied.
In case that the tractor is standing on a slope, its
wheels shall be wedged.
Lock the cabin
PGPPN173
To Next Page
Loading...
Need help?
General