Manufacturer’s warranty and liability
12
3. Manufacturer’s warranty and liability
ZMorph VX Multitool 3D Printer is designed to be modular and easy to service. In case
of technical difculty with any of the parts, it can be easily removed and shipped to man-
ufacturer for maintenance.
3.1 Scope of the warranty
3.1.1 Guarantor is only liable for the physical defects resulting from the inherent causes
in the sold product.
3.1.2 Duration of the warranty starts at the date of purchase of the product by the initial
Buyer. The Date of Purchase is the date specied in the sales invoice. The warranty peri-
od of the repaired product is extended by the time which was required to repair the prod-
uct (which includes the time from the delivery of the defective product with the complete
warranty claim until the date of returning the repaired product to the Costumer).
3.1.3 Warranty does not cover defects resulting from other causes than indicated in
clause 3.1.2, especially any defects resulting from:
a) improper use or application of the product;
b) improper product selection for the existing installation site conditions;
c) improper or inconsistent with User Guide installation (including improper connec-
tion to the main power supply), maintenance, storage or transport;
d) mechanical, chemical or thermal damages;
e) deliberate product damages;
f) damages ensuing as a result of non-original or inconsistent with Zmorph’s recom-
mendations or with the User Guide product use;
g) random events;
h) factors being result of major force, random events or any other external factors;
i) use of non-original parts or consumables;
j) modications, repair attempts, interference in the product carried out by any other
person than ZMorph representative or other representative authorized by ZMorph
to carry out any of the above mentioned actions;
k) continued usage of the product despite occurrences indicating an obvious defect;
l) improper transport methods provided by the Costumer;
3.1.4 The warranty does not apply to the consumable parts (such as nozzle, PTFE tube,
jagger, toothed belts, glass part of the table, bearing) unless failure has occurred due to
a defect in materials or manufacture.
To Next Page
Loading...
Need help?
General
