Zmorph VX - Filament Replacement During Printing

3D printing workow
63
12.5 Filament replacement during printing
Single Plastic Extruder
This function allows you to change the lament during the printing process. The new
lament must be of the same material as the new one (PLA/PLA) because the tempera-
ture of the extruder will be the same as for the lament that was there before.
Tap the "Left" gap in the
"Target: column.
Tap the needed tempera-
ture on the keyboard,
then OK.
Since the Dual PRO
toolhead has one nozzle,
the set up temperature
adjusts for left and right
lament. Wait the extrud-
er to heat up.
Tap the "Settings" menu. Choose "MORE". Choose "Filament
Change".
Go to the LOAD/UNLOAD
menu.
Feed the extruder by fol-
lowing steps from "load-
ing the lament" chapter.