Zmorph VX - CNC PRO Toolhead Safety Rules

CNC milling workow
125
13.8 CNC PRO Toolhead safety rules
Preparing the workstation
• Secure the room with the ZMorph VX machine against any improper usage (the key to
the room should be held only by a person authorized to operate the machine),
• Mark the entrance door to a room where a machine with a working CNC PRO toolhead
is used with a suitable sign to wear hearing protectors (e.g. headphones, stoppers),
• Depending on the material being processed, the CNC spindle can produce a noise
level up to 70dB. Noise is not a risk of hearing damage, but can cause discomfort and
stress due to prolonged exposure to a working device,
"Hearing protection required" sign
• Mark the entrance to the room where a machine with the CNC PRO toolhead is with a
proper sign saying that eye protection is required,
"Ear protection required" sign
• When working with the device with the spindle attached without covers (e.g. if ma-
terial is larger than the platform), provide personnel and bystanders in the room with
safety goggles,
• The electrical installation of the ZMorph VX requires it to be connected to a grounded
outlet,
• Place the device on a level and stable surface. The machine is equipped with a vibra-
tion-damping base but when working on uneven or sloping surface, vibrations can
cause the device to move,
• The room where the ZMorph VX device with the CNC PRO toolhead is located must be
well ventilated as vapours may escape from the device during operation,
• If you install a ZMorph VX device with the CNC PRO toolhead in a room where smoke