Laser cutting and engraving workow
129
14.3 Material xturing
For proper material xturing during laser cutting and engraving operations, you need to
mount aluminum bed that is added to every ZMorph VX Full Set or is available in store.
To learn how to change your worktable, check the 10.2 part of the manual.
CNC Worktable explained
Your aluminum worktable can be divided into two xturing areas.
For materials smaller than workspace of ZMorph VX there are T-slots milled for mount-
ing your workholding with M4 screws and square nuts.
For materials larger than workspace of ZMorph VX there are M4 threaded holes for
mounting your workholding with M4 screws.
14.2 Materials compatible with Laser Pro Toolhead
Laser PRO Toolhead allows for engraving and cutting in soft materials.
The list of tested materials is as follows:
• Wood derivatives: wood, plywood, wood bre boards
• Plastics: EPP, EVA foam
• Others: leather, felt, laser foil, cardboard, foamiran
To explore all materials please follow this link to ZMorph Materials Library:
http://bit.ly/ZMorphMaterialsLibrary
To Next Page
Loading...
