Health and safety
7
2. Health and safety at work
2.1 General safety information
This manual contains warnings and safety information for your ZMorph product. The
manual also indicates situations to which special attention should be paid, and warn-
ings about misuse or neglect of the device. It is also important to read the material
safety data sheets available at the address: https://zmorph3d.com. Regular updating
of the rmware is also important to prevent defects and damage. To keep track of
the latest instructions and software updates, it is recommended that you visit the site
https://support.zmorph3d.com regularly. Place the unit on a level and clean surface.
The device must be secured against overturning, falling from a height or being knocked
down by people moving in the vicinity.
• ZMorph VX Multitool 3D Printer generates very high temperatures during operation,
and has easily accessible moving parts. Caution is advised.
• When operating the printer, avoid situations that could cause burns or interfere with
the proper functioning of the device.
• Due to their size and specicity, ZMorph devices are not intended for use by children
under 14 years of age and persons with reduced manual, motor and psychomotor
skills. If the device is operated by handicapped or elderly people, the Manufacturer
recommends using assistance or supervision of appropriately trained persons.
• Do not leave the device unattended during operation, especially when working with
the Laser PRO toolhead.
• Periodically check the condition and functionality of the 3D printer to avoid potential
malfunctions.
• Switch off the device after nishing work.
• Regularly check the wear and tear of parts in the machine. The list of spare parts can
be found in the spare parts section.
• For assistance with technical problems and any maintenance work, please contact
the Technical support at the following address: https://support.zmorph3d.com
• Keep the unit away from heat sources, ammable materials, equipment emitting radi-
ation, moisture, water and other liquids.
• Before starting work, ensure that the device is out of reach for children and animals.
• Be careful not to drop, hit or shake the device.
• This device is not intended to operate in a potentially explosive atmosphere.
For detailed information on the safety of devices with different toolheads, please refer
to the separate chapters.
To Next Page
Loading...
Need help?
General
