Setting up ZMorph VX
28
9. Setting up ZMorph VX
9.1 Location requirements
After unpacking, place the machine in a suitable location.
• The machine should be placed on a stable, at surface with sufcient space above
the machine.
• Do not cover the machine with any materials during operation.
• The machine should not be exposed to moisture.
• The electrical installation of ZMorph VX requires it to be connected to a grounded wall
outlet.
• Do not use extension cords.
• Leave a 20 mm (minimum) space from the wall, for proper ventilation.
• Leave a 40 mm (minimum) space from the right side for better access to the SD card
slot.
• It is recommended that the room in which the machine is located should be well ven-
tilated, as hazardous vapors may escape from the machine during operation.
min. 20mm
550 mm
550 mm
750 mm 750 mm
660 mm
min.
40 mm
To Next Page
Loading...
