Setting up ZMorph VX
29
Open the front cover of
the machine to the point
where it touches with
the back cover. Magnet-
ic latches will keep the
cover open.
Remove the protective
tool band.
Gently remove the work-
table protection foams.
Prepare the spool holder
components and a 2.5
mm Allen key.
Look at the back of
ZMorph VX. Spool holder
attachment screws are
placed at the top of the
frame and highlighted on
the picture.
Loosen the frame screws
with a 2.5 mm Allen key.
9.2 Safety features removal
After the machine has been set up at the target workplace, before it is put into operation
for the rst time, remove the safety band from the toolhead and the protective foam
from the worktable.
9.3 Assembling the spool holder
For a better experience with the ZMorph VX machine, it is recommended to assemble
the dedicated spool holder.
To Next Page
Loading...
