Zmorph VX - Laser Engraving;Cutting File Starting

Laser cutting and engraving workow
135
Now you can check generated G-code and save it. Start your le according to 15.5 part
of the manual.
14.5 Laser engraving/cutting le starting (with calibration)
After uploading the le to an internal card or inserting an external SD card with the pre-
pared le:
Enter the 'New Job’
menu.
Go to the 'Choose le’
section.
Files uploaded to the in-
ternal SD card are locat-
ed in the 'INTERNAL’ tab,
les uploaded to the SD
card are located in the
'EXTERNAL’ tab,
NOTE: If the user inserted the external SD card the screen should jump forward to the
'Choose File' section screen on the 'EXTERNAL’ directory.
NOTE: If there was no previously chosen le, after pressing on the 'New job' menu the
screen will go directly to the 'Choose File' section.