Zmorph VX - Editing Parameters During Printing

3D printing workow
101
12.12 Editing parameters during printing
Single Plastic Extruder
Functions allowing to change parameters during the printing process:
Choose "More" The Heat function allows
you to change the tem-
perature of the extruder
and the table. Choose
"Heat" and tap the need-
ed temperature on key-
board, then OK
The "Filament Change"
function allows you to
change the lament
during the printout and is
described in the chapter
"Filament replacement
during printing".
Choose "Settings". The Print Speed part
allows you to change the
print speed. Select plus
to increase or decrease
the speed from 5% to
300% of the initial speed.
The "Fan Speed" section
allows you to change the
settings of the fan, the
"on" option turns on the
fan at 100% and the "off"
function turns off the fan.
After selecting the "auto"
option, the speed of the
fan is set according to
the G-code.