Zmorph VX - Preparing the Worktable

3D printing workow
76
12.9 Preparing the worktable
Positioning the worktable
works in two variants: to
the front and to the back
of the machine.
The variants are chang-
ing with every click on
"Prepare Bed" option.
Clean the surface of
the table and remove all
greasy spots. We recom-
mend paper towel and a
window cleaner.
Choose "New Job". Choose "Prepare Bed". Wait until the worktable
stops.
Manual 3-point calibra-
tion process is nished!
NOTE: Move the paper between the nozzle and the worktable surface, if the nozzle is too
low, the paper won't move. If the nozzle is too high above the surface the paper sheet
will be loose. The best conguration is when the piece of paper rubs against the nozzle
but it's not loose.