Zmorph VX - Autocalibration Process

3D printing workow
66
12.6 Autocalibration
Single Plastic Extruder
Tap the bottom arrow
on the screen to feed
80 mm of the lament.
Choose down arrow with
LEFT description to do
that.
Push the lament down
until you feel it has been
grabbed by the extruder.
Wait until the material
ows out of the nozzle.
Tap the feed button again
if necessary.
Repeat last 4 steps for
down arrow with RIGHT
description.
Remove the extruded
material. Choose "Done"
and wait until the extrud-
er starts printing again.
NOTE: Sometimes after clicking "DONE" the machine won't resume the work, in those
cases repeat the feeding by pressing one more time the "LEFT" down button and after
the extruder stops the feeding process press the "DONE" button.
NOTE: Before performing the automatic calibration make sure the worktable is clean
and prepared.
NOTE: During the automatic calibration process the printer is heating up.