Zmorph VX User Manual

3D printing workow
64
Wait until the extruder
stops printing and lifts
itself up.
Tap the "HEATING" menu
and check if the extruder
has the right tempera-
ture.
Tap the "LOAD/UNLOAD"
menu.
Tap the upper arrow on
the screen to remove 80
mm of the lament. At
rst, extruder will load 40
mm to prevent clogging.
Repeat if needed.
Insert new lament gen-
tly into the guide.
Tap the bottom arrow
on the screen to feed
80 mm of the lament.
Choose down arrow with
LEFT description to do
that.
Push the lament down
until you feel it has been
grabbed by the extruder
drive gear.
Wait until the material
ows out of the nozzle.
Tap the feed button
again if necessary.
Remove the extruded
material. Click "DONE",
the extruder will contin-
ue work from where it
stopped.
NOTE: Sometimes after clicking "DONE" the machine won't resume the work, in those
cases repeat the feeding by pressing one more time the "LEFT" down button and after
the extruder stops the feeding process press the "DONE" button.

Zmorph VX Specifications

General

Brand	Zmorph
Model	VX
Category	3D Printers
Language	English