Zmorph VX - Page 55

3D printing workow
55
Dual PRO Extruder
Mount the toolhead following the steps from "Mounting toolhead" chapter.
Prepare the material.
The 2 spools (2x 0.5 kg)
of lament are included
in the package (full set).
Take out the lament
rolls from the plastic foil,
remove moisture absorb-
er.
You can nd out what
kind of lament you
own by looking at the
sticker on the lament
roll. ZMorph VX package
comes with 0.5 kg white
and 0.5 kg silver PLA
materials.
Slide spools on the bar
and place it on the ma-
chine.
Push the lament down
until you feel it has been
grabbed by extruder drive
gear.
Wait until the material
ows out of the nozzle.
Tap the feed button
again if necessary.
NOTE: By tapping the button showing "80 mm" you can change the amount of extruded
lament to 15 or 5 mm.