Zmorph VX - Page 121

CNC milling workow
121
NOTE: If there was no previously chosen le, after pressing on the 'New job' menu the
screen will go directly to the 'Choose File' section.
Before starting the CNC milling process the machine must be calibrated to the mounted
material on the worktable. Skipping the calibration process may result in damaging the
milling cutter, machine or the toolhead and after that hurting the user.
Select the prepared
Gcode le.
If the prepared le or
folder is not visible on
the list press the up/
down arrow buttons to
navigate through the le
list.
Exiting the folder is done
by selecting the folder
icon with the upward-fac-
ing arrow.
Enter the 'Settings' sec-
tion.
Turn 'ON' your Spindle. Go to the 'Calibrate' sec-
tion.
After selecting the le,
press 'NEXT’.