Laser cutting and engraving workow
139
• It is necessary to mark the entrance door to the room where the device with the at-
tached Laser PRO is used with the appropriate sign to wear protective goggles,
Information sign - Eye protection required, wear protective goggles.
• Place in a visible place next to the laser workplace a label with the words "visible and
invisible laser radiation, protect the eyes and skin from direct or diffuse radiation",
• Provide personnel and bystanders in the room where the laser device works with pro-
tective eye shields (glasses, safety goggles) appropriate to the type of laser device,
• The appropriate safety goggles are those which, in a visible place (e.g. on the outside
of the frame) have the required markings (e.g. in the form O.D. = 3 for wavelengths of
660 nm or L = 3 for wavelengths of 820 nm). The value of 7 for the O.D. informs that
such glasses weaken the power of radiation falling on them 10000000 times. For ex-
ample, for a 1 W laser with such eyepieces, 0.1 uW of power will reach the eye and it
is a radiation level that is completely safe for the human eye,
• Provide personnel and bystanders staying in the room where the laser device works
with mouth and nose masks equipped with a lter absorbing smoke particles (FFP3),
• Electrical installation of the ZMorph VX machine requires connecting it to a grounded
socket,
• Provide a room in which a working ZMorph machine with Laser PRO is installed in a
valid powder extinguisher, it should be located in an accessible place and marked with
appropriate markings,
• When installing the ZMorph machine with Laser PRO in a room where smoke detec-
tors are installed, make sure that they do not cause false alarms,
• The room in which the ZMorph machine with the Laser PRO machine is located must
be well ventilated, hazardous vapors may escape from the machine.
Safety instructions for handling LaserPRO on ZMorph VX
1. General information.
• The ZMorph VX machine with Laser PRO mounted should be used in a separate
room without the possibility of outsiders getting in,
• Regardless of the laser class, it is forbidden to look at the laser beam (i.e. to look
into the opening of the laser from which the beam is emitted); this also applies
to the reected beam,
To Next Page
Loading...
Need help?
General
