Machine specication
23
• X-carriage/Toolhead mount - element responsible for holding down toolhead, as well
as automatic calibration. X-carriage has linear bearings mounted that slide on stain-
less steel rods and is also a housing for a calibration element - strain gauge. Toolhead
mounting is described in 10.1 part of this manual.
• Y-carriage/Worktable xation system - specially designed lever and magnets system
for quick and effortless changing between additive and subtractive work surfaces.
worktable changing is described in 10.2 part of this manual.
• The bottom cover of the machine - responsible for the protection of the motherboard
and power supply from external damage and dirt. Allows air exchange for cooling
internal electronics.
To Next Page
Loading...
