Zmorph VX - Page 59

3D printing workow
59
Dual PRO Extruder
To preheat the extruder, follow these steps.
Choose the "Mainte-
nance" from the LCD
touchscreen menu.
Choose "Load Filament". Choose PARK TOOL, wait
for the machine to posi-
tion the toolhead. When
done, choose "PLA" to
preheat the material.
Wait till extruder reaches
the proper temperature.
The yellow HEATING sign
will change colour from
yellow to green.
Tap the LOAD/UNLOAD
menu.
Tap the upper LEFT
arrow on the screen to
remove 80 mm of the
lament. At rst, extruder
will load 40 mm to pre-
vent clogging.
Tap the upper RIGHT
arrow on the screen to
remove 80 mm of the
lament. At rst, extruder
will load 40 mm to pre-
vent clogging. Repeat if
needed
NOTE: Third menu named ALL maintain both la-
ments at the same time. Tap down arrow with ALL
description to feed both laments.
NOTE: By tapping the button showing "80 mm" you
can change the amount of extruded lament to 15 or
5 mm.