Chapter 10 Quality of Service (QoS)
PMG5317-T20A User’s Guide
143
10.6.1 Add/Edit a QoS Shaper
Click Add New Shaper in the Shaper Setup screen or the Edit icon next to a shaper to show the
following screen.
Figure 64 Shaper Setup: Add/Edit
The following table describes the labels in this screen.
10.7 The QoS Policer Setup Screen
Use this screen to view QoS policers that allow you to limit the transmission rate of incoming traffic
and apply actions, such as drop, pass, or modify the DSCP value for matched traffic. Click Network
Setting > QoS > Policer Setup. The screen appears as shown.
Outgoing
Interface
This shows the name of the GPON Device's interface through which traffic in this shaper
applies.
Rate Limit
(kbps)
This shows the average rate limit of traffic bursts for this shaper.
Modify Click the Edit icon to edit the shaper.
Click the Delete icon to delete an existing shaper. Note that subsequent rules move up by
one when you take this action.
Table 40 Network Setting > QoS > Shaper Setup (continued)
LABEL DESCRIPTION
Table 41 Shaper Setup: Add/Edit
LABEL DESCRIPTION
Active Select to enable or disable this shaper.
Interface Select the GPON Device's interface through which traffic in this shaper applies
Rate Limit Enter the average rate limit of traffic bursts for this shaper.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
