PMG5317-T20A User’s Guide
270
CHAPTER 36
SLID
36.1 SLID
To change your GPON Device’s Subscriber Location ID (SLID) setting, click Maintenance > SLID.
The screen appears as shown. The SLID identifies your device to the GPON service provider’s
Optical Line Terminal (OLT). If your GPON service provider gave you an SLID to use, enter it in this
screen.
Figure 163 Maintenance > SLID
The following table describes the fields in this screen.
Table 127 Maintenance > SLID
LABEL DESCRIPTION
Enable SLID Select this to have the GPON Device use the SLID to identify itself to the OLT.
SLID Value Enter the SLID used for gaining access to the service provider’s network. It is case-
sensitive, so make sure [Caps Lock] is not on.
Apply Click Apply to save your changes back to the GPON Device.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
