Chapter 20 Voice
PMG5317-T20A User’s Guide
217
20.5.1 The Phone Device Edit Screen
Use this screen to control which SIP account and PSTN line each phone uses. Click an Edit icon in
the VoIP > Phone > Phone Device to open the following screen.
Figure 122 VoIP > Phone > Phone Device > Edit
Each field is described in the following table.
Outgoing SIP
Number
This field displays the SIP number that you use to make calls on this phone port.
Modify
Click the Edit icon to configure the SIP account.
Apply Click this to save your changes and to apply them to the GPON Device.
Cancel Click this to set every field in this screen to its last-saved value.
Table 92 VoIP > Phone > Phone Device
LABEL DESCRIPTION
Table 93 VoIP > Phone > Phone Device > Edit
LABEL DESCRIPTION
SIP Account to
Make Outgoing
Call
Select the SIP account you want to use when making outgoing calls with the analog
phone connected to this phone port.
SIP Account(s) to
Receive
Incomming Call
Select a SIP account if you want to receive phone calls for the selected SIP account on
this phone port.
If you select more than one SIP account for incoming calls, there is no way to distinguish
between them when you receive phone calls. If you do not select a source for incoming
calls, you cannot receive any calls on this phone port.
Immediate Dial
Enable
Select this if you want to use the pound key (#) to tell the GPON Device to make the
phone call immediately, instead of waiting the number of seconds you selected in the
Dialing Interval Selection field of the VoIP > SIP > SIP Service Provider > Add
New Provider/Edit screen.
If you select this, dial the phone number, and then press the pound key. The VMG makes
the call immediately, instead of waiting. You can still wait, if you want.
OK
Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
