PMG5317-T20A User’s Guide
189
CHAPTER 16
MAC Filter
16.1 Overview
You can configure the GPON Device to permit access to clients based on their MAC addresses in the
MAC Filter screen. This applies to wired and wireless connections. Every Ethernet device has a
unique MAC (Media Access Control) address. The MAC address is assigned at the factory and
consists of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know
the MAC addresses of the devices to configure this screen.
16.2 The MAC Filter Screen
Use this screen to allow wireless and LAN clients access to the GPON Device. Click Security > MAC
Filter. The screen appears as shown.
Figure 102 Security > MAC Filter
To Next Page
Loading...
