Chapter 1 Introduction
PMG5317-T20A User’s Guide
20
1.8 The WPS Button
You can use the WPS button on the back of the device to activate WPS in order to quickly set up a
wireless network with strong security.
Figure 6 WPS Button
1.8.1 Using the WPS Button
1 Make sure the POWER LED is on (not blinking).
2 Before you start with WPS function, please make sure the wireless LAN is enabled, and the LED
light shines green. If wireless LAN is not enabled, see Section 1.7 on page 19 to activate.
Press the WPS button for more than 5 seconds and release it when the LED turns green. If you
want to turn it off, press the WPS button for 5 seconds again. See above for WPS button location.
3 Press the WPS button on a compatible device within 2 minutes of pressing the button on the GPON
Device. The WLAN LED should flash in amber while the GPON Device sets up a WPS connection
with the other wireless device.
4 Once the connection is successfully made, the WLAN LED shines green.
1.9 Wall Mounting
You may need screw anchors if mounting on a concrete or brick wall.
1 Select a position free of obstructions on a wall strong enough to hold the weight of the device.
2 Mark two holes on the wall at the appropriate distance apart for the screws.
Table 2 Wall Mounting Information
Distance between holes 142 mm
M4 Screws Two
Screw anchors (optional) Two
To Next Page
Loading...
