Chapter 1 Introduction
PMG5317-T20A User’s Guide
21
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
3 If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the
full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way
in - leave a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the
screws all the way in - leave a gap of about 0.5 cm.
4 Make sure the screws are fastened well enough to hold the weight of the GPON Device with the
connection cables.
5 Align the holes on the back of the GPON Device with the screws on the wall. Hang the GPON Device
on the screws.
Figure 7 Wall Mounting Example
To Next Page
Loading...
