Chapter 13 Interface Grouping
PMG5317-T20A User’s Guide
174
13.2.2 Interface Grouping Criteria
Click the Add button in the Interface Grouping Configuration screen to open the following
screen.
Figure 89 Interface Grouping Criteria
The following table describes the fields in this screen.
# This shows the index number of the rule.
Filter Criteria This shows the filtering criteria. The LAN interface on which the matched traffic is received
will belong to this group automatically.
WildCard
Support
This shows if wildcard on DHCP option 60 is enabled.
Modify Click the Modify icon to edit this rule from the GPON Device.
OK Click OK to save your changes back to the GPON Device.
Cancel Click Cancel to exit this screen without saving.
Table 63 Interface Group Configuration (continued)
LABEL DESCRIPTION
Table 64 Interface Grouping Criteria
LABEL DESCRIPTION
Source MAC
Address
Select this option and enter the source MAC address of the packet.
DHCP Option
60
Select this option and enter the Vendor Class Identifier (Option 60) of the matched traffic,
such as the type of the hardware or firmware.
Enable
wildcard
Select this option to be able to use wildcards in the Vendor Class Identifier configured for
DHCP option 60.
DHCP Option
61
Select this and enter the device identity of the matched traffic.
DHCP Option
125
Select this and enter vendor specific information of the matched traffic.
Enterprise
Number
Enter the vendor’s 32-bit enterprise number registered with the IANA (Internet Assigned
Numbers Authority).
To Next Page
Loading...
