Chapter 13 Interface Grouping
PMG5317-T20A User’s Guide
173
Figure 88 Interface Group Configuration
The following table describes the fields in this screen.
Table 63 Interface Group Configuration
LABEL DESCRIPTION
Group Name Enter a name to identify this group. You can enter up to 30 characters. You can use letters,
numbers, hyphens (-) and underscores (_). Spaces are not allowed.
WAN Interfaces
used in the
grouping
Select the WAN interface this group uses. The group can have up to one GPON interface.
Select None to not add a WAN interface to this group.
Available LAN
Interfaces
Select one or more LAN interfaces (Ethernet LAN, HPNA or wireless LAN) on the right
interface list and use the left arrow to move them to the interface list on the left to add the
interfaces to this group.
To remove a LAN or wireless LAN interface from the interface list on the left, use the right-
facing arrow.
Automatically
Add Clients
With the
following DHCP
Vendor IDs
Click Add to identify LAN hosts to add to the interface group by criteria such as the type of
the hardware or firmware. See Section 13.2.2 on page 174 for more information.
To Next Page
Loading...
