ZyXEL Communications PMG5317-T20A - The Dynamic DNS Screen

Chapter 12 Dynamic DNS Setup
PMG5317-T20A User’s Guide
169
The following table describes the labels in this screen.
12.3 The Dynamic DNS Screen
Use this screen to change your GPON Device’s DDNS. Click Network Setting > DNS > Dynamic
DNS. The screen appears as shown.
Figure 85 Network Setting > DNS > Dynamic DNS
The following table describes the fields in this screen.
Table 60 DNS Entry: Add/Edit
LABEL DESCRIPTION
Host Name Enter the host name of the DNS entry.
IPv4 Address Enter the IPv4 address of the DNS entry.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 61 Network Setting > DNS > > Dynamic DNS
LABEL DESCRIPTION
Dynamic DNS Setup
Dynamic DNS Select Enable to use dynamic DNS.
Service Provider Select your Dynamic DNS service provider from the drop-down list box.
Host Name Type the domain name assigned to your GPON Device by your Dynamic DNS provider.
You can specify up to two host names in the field separated by a comma (",").
Username Type your user name.
Password Type the password assigned to you.
Enable Wildcard
Option
Select the check box to enable DynDNS Wildcard.
Enable Offline
Option (Only
applies to custom
DNS)
Check with your Dynamic DNS service provider to have traffic redirected to a URL (that
you can specify) while you are off line.
Dynamic DNS Status